Wega LB 4712 - Activation of the Machine; Preparing the Coffee; Pod Preparation

English
29
espresso coffee machine - user instructions
7
12
0
4. ACTIVATION OF THE MACHINE
Before starting the machine, make sure that the level of water in the boiler is higher than the minimum level
on the level-check window (7). If there is no water (first installation or after boiler maintenance), it is neces-
sary to fill the boiler in advance, so as to prevent overheating of the heating element.
Proceed as follows:
• Open the water tap of the water mains and of the softener.
• Turn the switch to position “1” (electrical power supplied to the pump for automatic boiler filling and
machine services) and wait for the boiler to be automatically filled with water.
• Turn the switch to position “2” (full electrical power supplied, including the heating element in the boiler)
and wait for the machine to warm up completely.
5. PREPARING THE COFFEE
5.1 POD PREPARATION
• Insert the pod into the filter holder, as shown in the figure;
• hook the filter holder to the group without closing it too tightly in order to avoid excessive
wear of the seal;
2-Cup
filter holder
1-Cup
filter holder
• during the machine’s warm-up phase (roughly 20 minutes), the negative pressure valve will
release steam for a few seconds until the valve itself closes.
• before using the machine, run dry deliveries with the fi lter holder attached for a few seconds to
release any air which may be in the circuit, so that the delivery groups are completely heated.
• before using the machine, dispense a few servings of coffee to check the operating pressure of
the machine.
Use “LAVAZZA BLUE” pods only.
Do not insert your fi ngers into the fi lter-holder or any other object.
The pods are to be used once only.
Be careful to insert the pod in the correct fi lter holder
(with 1 or 2 spouts).
B
E
S
T
L
A
V
A
Z
Z
A
U
L
T
I
M
A
T
E
E
S
P
R
E
S
S
O
B
E
S
T
L
A
V
A
Z
Z
A
U
L
T
I
M
A
T
E
E
S
P
R
E
S
S
O