Weider 170 Tc Bench - Part Identification Chart

5
Refer to the drawings below to identify small parts used in assembly. The number in parentheses by each draw-
ing is the key number of the part, from the PART LIST near the end of this manual. IMPORTANT: If you cannot
f
ind a part in the hardware kit, check to see if it has been preassembled.
M8 Zinc
Locknut (36)
M10 Locknut
(25)
M6 Washer (20)
M8 Washer (12)
M10 Washer (26)
M8 Zinc
Washer (35)
M8 Locknut
(13)
M6 x 16mm
Screw (21)
M6 x 38mm Screw (22)
M8 x 53mm Bolt (14)
M8 x 38mm
Carriage Bolt (29)
M10 x 55mm Bolt (30)
M10 x 137mm Bolt (28)
M10 x 51mm Bolt Set (24)
PART IDENTIFICATION CHART