Weider 8225 - Page 7

5. Attach the Front Upright (19) to the Base (15) with
two 5/16” Nylock Nuts (4). Do not tighten the
Nylock Nuts yet.
Attach the Front Upright (19) to the Rear Upright
(17) with the 5/16” x 3/4” Screw (129) and a 5/16”
Flat Washer (45).
6. Press а 1” х 1 1/2” Inner Сар (62) into each end of
the Press Stop (44).
Attach the two VKR Frame Stop Bumpers (61) to
the VKR Frame Stop (44) with 1/2” Tap Screws
(127).
Attach the VKR Frame Stop (44) to the Front
Upright (19) with a 5/16” x З 1/2” Bolt (128), two
5/16” Flat Washers (45) and a 5/16” Nylock Nut (4).
Make sure that the VKR Frame Stop is attached
so the two VKR Frame Stop Bumpers (61) are
on top.
7. Remove the 3/8” Nylock Nut (63) from the indicat-
ed 3/8” x 2 3/4” Bolt (55). Set the Nylock Nut
aside—t will be used again in assembly step 11.
Remove the Bolt, the 3/8” Flat Washer (64) and the
two 5/8” x 5/16” Spacer (121) from the Front
Upright (19).
Slide the VKR Frame (79) around the Rear Upright
(17) as shown. Fit the bracket on the end of the
VKR Frame around the lower end of the Pivot Arm
(75) as shown. Align the hole in the bracket with
the hole in the lower end of the Pivot Arm. Slide the
3/8” Flat Washer (64) and one 5/8” x 5/16” Spacer
(121) onto the 3/8” x 2 3/4” Bolt (55). Insert the Bolt
through the Front Upright, the VKR Frame and the
Pivot Arm. Slide the other 5/8” x 5/16” Spacer (121)
onto the Bolt.