Weider 8507 - Assembly: Arm and Handle Attachment; Arm Caps, Axles, Pads, and Handles Installation

8
11. Press a 1 3/4” Square Inner Cap (44) into each end
of an Arm (46).
A
pply lubricant to the lower axles on the Arm Frame
(52). Slide an Arm (46) onto one of the axles. Hold
t
wo 1” Retainers (54) and a 1” Round Cover Cap
(55) against the lower end of the axle. The teeth
on the Retainers must bend toward the Round
Cover Cap (see the inset drawing). Tap the
Retainers and Round Cover Cap onto the axle.
Assemble the other Arm (46) to the Arm Frame (52)
in the same manner.
12. Insert the two 4 1/2” “L” Pins (60) down through the
indicated holes in the Arm Frame (52) and the Arms
(46).
13. Wet both Arms (46) with soapy water. Slide a 7 3/4”
Pad (45) onto each Arm.
Slide a Handgrip (12) into the indicated end of a 7”
Handle (47). Insert the Handle into one of the Arms
(46). Attach the Handle with a 5/16” x 2.1/4” Bolt
(33), two 5/16” Washers (8), a 1/2” x 3/8” Spacer
(51), and a 5/16” Nylon Locknut (3).
Attach a 7” Handle (47) to the other Arm (46) in the
same manner.
13
12
11
52
33
45
45
3
8
8
46
46
47
47
12
49
46
52
60
Bracket
L
ubricate Axle
54
55
46
44
44
Axle
54
55
51
All manuals and user guides at all-guides.com