15
26. Attach the Backrest (24) to the Backrest Frame
(17) with four M6 x 38mm Screws (128) and four
M
6 Washers (126).
27. Insert the rod on the Backrest Frame (17) into the
slot in the Seat Carriage (16).
Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
17
2
4
126
126
128
128
27
26
17
16
17
16
28.
Attach the Curl Pad (26) to the Curl Post (12) with
two M6 x 16mm Screws (108).
29
.
Make sure that all parts have been properly tight
-
ened.
The use of the remaining parts will be
explained in ADJUSTMENTS, beginning on the
next page.
Before using the resistance system, turn on
the console and change the resistance setting
as described in CONSOLE OPERA
TION on
page 21.
28
12
108
26
To Next Page