20
2
3
4
1
5
20
44
STORING THE RESISTANCE SYSTEM
To store the resistance system, first remove the Curl
P
ad (not shown) and the Leg Lever (not shown) from
the resistance system. Secure the Seat (25) at the
position closest to the Front Leg (4) (see ADJUSTING
THE SEAT above). Next, remove the Storage Knob
(
44) from the Upright Base (2). Lift the Front Leg
toward the Top Frame (20). Tighten the Storage Knob
into the side of the Upright Base and into the Rail (5).
To move the resistance system, stand behind the
Upright (3) and place the toe of your shoe on the end
of the Base (1). Tilt the resistance system back onto
the Wheels (49) and roll it to the new location.
WARNING: Make sure that the
Storage Knob (44) is in place and fully tight-
ened each time the resistance system is used.
25
49
To Next Page