11
17
38
30
30
17. Wet the ends of the Lat Bar (38) with a small
amount of soapy water. Slide the Handgrips (30)
onto the ends of the Lat Bar.
18. Make sure all parts of the weight rack are properly tightened. In addition, pull each cable a few times
to make sure the cables move smoothly over the pulleys. If the cables do not move smoothly, locate
and correct the problem. When weights are used, the cables may be damaged if they are incorrectly
routed.
The use of all remaining parts will be explained in ADJUSTMENTS, beginning on page 12.
To Next Page
Loading...
