Weider PRO XT75 - PART IDENTIFICATION CHART

5
M10 Nylon Locknut (31)
M8 Nylon Locknut (32)
M10 x 66mm Bolt (37)
51mm Spacer (43)
24mm Spacer (42)
M10 x 45mm Bolt (34)
18mm Spacer (45)
28mm Spacer (44)
M8 Flat Washer (40)
M10 Flat Washer (41)
M10 x 50mm Bolt (47)
M8 x 72mm Bolt (35)
M10 x 75mm Bolt (36)
M10 x 78mm Bolt (33)
Refer to the drawings below to identify small parts used in assembly. The number in parentheses by each draw-
ing is the key number of the part, from the PART LIST in the center of this manual. Note: Some small parts
may have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached.
PART IDENTIFICATION CHART