Weider Ultraforce XT 70032 User Manual

WEIDER HEALTH and FITNESS
C] Assemble 5/16" FLAT WASHERS (70) onto two 5/16" X 2 3/4" HEX HEAD BOLTS (62) and attach the TOP FRAME (8) to
the ARM PRESS FRAME UPRIGHT (4) by bolting down through the top of the Top Frame and then through the brackets of the
Upright. Fasten with 5/46" NYLON LOCK NUTS (71) and tighten only finger tight.
[0
Attach
the
bottom
of
the
ARM
PRESS
BRACKET
(9)
to
the
Welded
Stop
Tube
on
the
ARM
PRESS
UPRIGHT
(4)
by
assembling
a
5/16"
FLAT
WASHER
(70)
and
a
1"
O.D.
X
1"
LONG
BUSHING
(105)
onto
a
5/16"
X
3"
HEX
HEAD
BOLT
(63)
and
bolting
down
through
the
Arm
Press
Bracket
and
then
through
the
Welded
Stop
Tube.
Assemble
on
another
5/16"
FLAT
WASHER
(70)
and
secure
with
a
5/16"
NYLON
LOCK
NUT
(71)
only finger
tight.
L1 Cap each end of the Top Frame with 2" SQUARE PLASTIC INSERT CAPS (96).
ва swe"xi'HExHEADBOLT | 2 |
тч SHe"NYLONLOCKNUT | 2 |
po w"X2wcARRMAGEBOLT | 2 |
| a І
| 2 |
СЭН
“ату:
86 1/4" FLAT WASHER
87 1⁄4" NYLON LOCK NUT
95 2" SQUARE PLASTIC COVER CAP
C] Assemble the SEAT BRACE
(10) to the rear of the SEAT
FRAME (5) by bolting with a
4" X 2 1/2" CARRIAGE
BOLT (80) down through a
SEAT MOUNTING PLATE
(11), the Seat Frame, and then
the Seat Brace. Secure with a
1⁄4" NYLON LOCK NUT (87).
C] Attach the legs of the SEAT
BRACE (10) to the BASE "T"
using 5/16" X 1“ HEX HEAD
BOLTS (64) to bolt through the
legs of the Seat Brace and
then the Base "T*. Fasten with
5/16" NYLON LOCK NUTS
(71). (SEE DETAIL A.)
C] Attach а SEAT MOUNTING
PLATE (11) to the front hole of
the SEAT FRAME (5) бу
bolting with a 1/4" X 2 1/2"
CARRIAGE BOLT (80) down
through the Mounting Plate
and then the Seat Frame.
Assemble a 1/4" FLAT
WASHER (86) onto the bolt
and secure with a 1/4" NYLON
LOCK NUT (87).
О Сар the Cross-member Tube
of the BASE "T" (1) with 2"
SQUARE PLASTIC COVER
CAPS (95).

Weider Ultraforce XT 70032 Specifications

General

Brand	Weider
Model	Ultraforce XT 70032
Category	Fitness Equipment
Language	English