Operating instructions, Piercing press, Weidmann Type MV5 Version: May 2019 Page 7
Maintenance
This operation may be undertaken by: third parties; mechanics
Maintenance tasks must be carried out as follows:
Use a universal grease to lubricate the grease nipple on the drive mechanism every 6 months
Use slideway oil to lubricate the guide rails on a monthly basis
Use slideway oil to lubricate the press spindle on a monthly basis
Check the Teflon brake disk on the hand wheel every year and replace as necessary
Replacing the Teflon brake disk
Only original replacement parts may be used for this procedure (Order no.: Teflon brake disk).
Lower the press spindle onto the table plate
Risk of crushing
Do not place your hands within the area of risk caused by the spindle
Apply the spindle brake
Risk of being pulled in
Do not touch the gear rim
Loosen and remove the star handle in the centre of the hand wheel
Remove the plate washer and spacing washer
Remove the hand wheel
Remove the slot key
Remove the Teflon brake disc and replace with a new brake disc
Insert the slot key
Mount the hand wheel
Fit the galvanised spacing washer
Fit the black plate washer with the indentation onto the hand wheel
Fit and tighten the star handle in the centre of the hand wheel
To Next Page
Loading...