Why is my weinor BiLine Combio-868 MVLED Remote Control awning/light not responding?
Your Weinor awning or light might not be responding to the remote control due to several reasons: there is no power supply, the awning/light hasn't been programmed, or the batteries in the remote are dead. You should reconnect the power supply, program the awning/light, or replace the batteries in the hand transmitter.
How to fix weinor BiLine Combio-868 MVLED when the drive moves in the wrong direction?
If the drive is moving in the wrong direction, it's likely that the directions were programmed incorrectly. To fix this, delete the channel and program it correctly.
What to do if Weinor Remote Control awning retracts immediately after a DOWN command?
If your awning extends only a short way and then retracts after a DOWN command, this could be due to a few reasons: 1. The receiver might be in lock mode because the maximum wind factor on the sun/wind or sun/wind/rain sensor was exceeded. This lock mode will be removed automatically 15 minutes after the maximum wind factor was last exceeded. 2. The WeiTronic Agido-868 product protection sensor might have been triggered. The device unlocks automatically after 15-20 minutes. 3. A programmed sun/wind or sun/wind/rain sensor could be faulty or incorrectly installed. The device will only unlock when the fault has been remedied.
Why does my weinor BiLine Combio-868 MVLED awning move UP and cannot be stopped?
If your awning moves UP and cannot be halted or extended, it is likely due to a "Wind alarm". This means that a programmed sun/wind and/or sun/wind/rain sensor or Agido-868 product protection sensor has been triggered. The device unlocks automatically after the designated period.
Why does my weinor BiLine Combio-868 MVLED awning stop and then continue after an UP command?
If the awning stops after a while and then continues following an UP command, the Agido-868 battery is likely empty. Replace the batteries in a programmed WeiTronic Agido-868 product protection sensor.
How to teach in the weinor BiLine Combio-868 MVLED awning if it cannot be taught in with the hand transmitter?
If the awning cannot be taught in with either the BiEasy or Remoto hand transmitter, it may be because the unidirectional transmitter/ sensor e.g. Remoto or the bidirectional transmitter/ sensor e.g. BiEasy is still taught in. Delete the old transmitter completely, then teach in the awning with the new transmitter.
General| Brand | weinor |
|---|---|
| Model | BiLine Combio-868 MVLED |
| Category | Remote Control |
| Language | English |
To Next Page
