weinor BiLine Combio-868 MVLED - Troubleshooting

Assembly and installation instructions
Item number 116692-0000
We reserve the right to make technical
changes
Version 2
15.11.2013
Page 9/28
BiLine Combio-868 MVLED/ MLED
Troubleshooting 5
Type of fault
Cause
Remedy
Awning/light does not react to
the signal sent by the hand
transmitter
• No power supply • Reconnect power supply
• Awning/light has not
been programmed
• Program awning/light
• Empty batteries in hand
transmitter
• Replace batteries
Drive moves in wrong direction
• Directions have been
programmed incorrectly
• Delete channel and
program correctly
Following a DOWN command,
awning extends only a short
way, then immediately retracts
• Receiver is in lock mode:
maximum wind factor on
sun/wind or sun/wind/rain
sensor exceeded
• Lock mode is removed
automatically 15 minutes
after the maximum wind
factor was last exceeded
• WeiTronic Agido-868
product protection sensor
has been triggered in last
few minutes
• The device unlocks
automatically after 15-20
minutes
• Programmed sun/wind or
sun/wind/rain sensor is
faulty or incorrectly
installed
• The device will only unlock
when the fault has been
remedied
Awning moves UP and cannot
be halted or extended
• "Wind alarm":
Programmed sun/wind
and/or sun/wind/rain
sensor or Agido-868
product protection sensor
has been triggered
• The device unlocks
automatically after the
designated period
Following an UP command,
the awning stops after a while
then continues
• Agido-868 battery empty • Replace batteries in a
programmed WeiTronic
Agido-868 product
protection sensor
The awning cannot be
taught in
a) with the BiEasy hand
transmitter
b) with the Remoto hand
transmitter
a) the unidirectional
transmitter/ sensor
e.g. Remoto is still
taught in
b) the bidirectional
transmitter/ sensor
e.g. BiEasy is still
taught in
• delete old transmitter
completely then teach in
the awning with the new
transmitter
Table 3: Troubleshooting