weinor BiRec MVLED - 7 Maintenance and Repairs; Maintaining the Remote-Receiver

BiConnect BiRec MVLED/MLED
Version 4
2020-07-08
Assembly and installation instructions/ Instructions de montage et d’installation
Item number/
We reserve the right to make technical changes/ Sous reserve de modifications techniques
Numéro d’article
116692-0000
Page 12/28
7
Maintenance and repairs
Electric shock!
 Work involving 230 V mains may only be carried out by a trained electrician.
 Disconnect the unit from the power supply before performing any work.
7.1 Maintaining the remote-receiver
It is not possible to carry out repairs on the remote-receiver itself. In the event of a malfunction or
defect, the device will need to be replaced.
If a component does not react as expected, you must check the connections.
You should:
• check that the connectors are correct and have been tightly connected
• test all line contacts
DANGER