weinor BiRec MA - User Manual

Questions and Answers

K
Kayla HernandezAug 11, 2025
Why is my weinor Receiver awning not responding to the hand transmitter?
- H
  Heather NelsonAug 12, 2025
  If your weinor Receiver-controlled awning isn't responding to the hand transmitter, there could be a few reasons. First, ensure the power supply is properly connected. Second, the awning might not be programmed, so you'll need to program it. Lastly, check the batteries in the hand transmitter and replace them if they're empty.
B
Brian FernandezAug 17, 2025
How to fix weinor Receiver awning drive moving in the wrong direction?
- B
  Brandi EnglishAug 17, 2025
  If the drive of your weinor Receiver awning moves in the wrong direction, it's likely that the directions were programmed incorrectly. To fix this, delete the channel and program it correctly.
S
Samuel BishopAug 23, 2025
What to do if weinor Receiver awning retracts immediately after a DOWN command?
- A
  Anne TurnerAug 23, 2025
  If your weinor Receiver awning extends only a short way and then retracts after a DOWN command, it could be due to several reasons: * The receiver might be in lock mode because the maximum wind factor on the sun/wind or sun/wind/rain sensor was exceeded. This lock mode will be removed automatically 15-20 minutes after the maximum wind factor was last exceeded. * The BiSens Agido-3V product protection sensor may have been triggered recently. The device unlocks automatically after 15-20 minutes. * The programmed sun/wind or sun/wind/rain sensor might be faulty or incorrectly installed. The device will only unlock when the fault has been remedied.
S
Steve WardAug 29, 2025
Why does my weinor Receiver awning move UP and cannot be stopped?
- C
  Christine SandersAug 29, 2025
  If your weinor Receiver awning moves UP and cannot be halted or extended, it indicates a "Wind alarm." This means a programmed sun/wind and/or sun/wind/rain sensor or BiSens Agido-3V product protection sensor has been triggered. The device unlocks automatically after the designated period.
S
Sonya FrySep 4, 2025
Why does my weinor Receiver awning stop and continue after an UP command?
- J
  Joseph RosalesSep 4, 2025
  If, after giving an UP command, your weinor Receiver awning stops and then continues, the BiSens Agido-3V battery may be empty. Replace the batteries in the programmed BiSens Agido-3V product protection sensor.