BiConnect BiRec Ma + MA-K
Assembly and installation instructions/ Instructions de montage et d’installation
We reserve the right to make technical changes/ Sous reserve de modifications techniques
2 Safety notes
2.1 Fundamental safety notes
• Keep unauthorised persons away from the unit until it is ready for use.
• The connected electrical load must tally with that listed in the technical data.
• The regulations of the local energy providers and the VDE 0100 provisions for humid and wet
areas must be observed.
• Only connect the remote receiver to devices approved by weinor.
2.2 Electricity hazards
• Work involving connections to 230 V mains may only be carried out by a trained electrician.
• Disconnect the unit from the power supply before performing any work.
• weinor recommendation: a residual current circuit breaker (trip switch) should also be fitted to
protect the indoor installation.
2.3 Intended use
The BiRec MA + MA-K remote receiver has been designed solely to operate weinor motors
installed in awnings.
2.4 Improper use
The remote receiver may only be used on the condition that a malfunctioning hand transmitter or
remote receiver does not pose a danger to people, animals or objects. The device may only be
connected to devices and units approved by weinor. The system may not be operated in areas
where the transmitted signals might interfere with other devices (e.g. in hospitals or at airports).
To Next Page
Loading...
Need help?
General
