BiConnect BiRec Ma + MA-K
Assembly and installation instructions/ Instructions de montage et d’installation
We reserve the right to make technical changes/ Sous reserve de modifications techniques
4 Getting started
4.1 Pre-programmed system
The system is usually supplied pre-programmed. This means that all the components can be
controlled with the hand transmitter supplied. In this case, once the system is assembled and
installed, you can immediately start using the remote receiver and check that all the functions are
4.2 Unprogrammed system
On rare occasions or if servicing has been carried out, however, the system will need to be
programmed on site. This is done by pairing up the hand transmitter and remote receiver (see
4.3 Checking the functions
Once all the installation work is completed, you will need to check that the system is working
properly.
• Does the awning extend
fully?
• Does the awning retract
fully?
Briefly press DOWN key
Awning extends fully
Briefly press UP key
Awning retracts fully
• If they are being used, are
all the sensors
programmed for the
correct direction?
• Simulated "wind" on the
sun/wind (or
sun/wind/rain) sensor
• Shake the drop profile (if
an Agido product
protection sensor is
Table 2: Checking the functions
If the components do not react as expected, check the table below to locate the likely cause.
To Next Page
Loading...
Need help?
General
