EasyManua.ls Logo

weinor BiConnect BiRec On/Off - User Manual

weinor BiConnect BiRec On/Off
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Remote receiver BiRec On/ Off
Assembly and installation instructions
BiConnect BiRec On/ Off
Version 1
2016-01-01
Assembly and installation instructions/ Notice de montage et d’installation
Item number/
We reserve the right to make technical changes/ Sous reserve de modifications techniques
Numéro d’article
119759-0000
Page 1/20
Remote-receiver BiRec On/Off to control weinor products all around the patio
Récepteur radio BiRec On/ Off
Notice de montage et d’installation
Récepteur radio BiRec On/Off pour la commande de produits weinor pour la terrasse
ENGLISH
FRANÇAIS
BiRec On/Off
BiRec On/Off-i
Please read these instructions and observe their content and warnings before commencing any
installation work. This information is important for the installation and the proper use of the
material.
Follow the specified installation steps precisely and observe the details and
recommendations.
Only trained personnel may put the units into operation.
Avant le montage, veuillez lire cette notice et en respecter le contenu ainsi que les mises en garde.
Ces indications sont essentielles en vue du montage et de l'utilisation correcte du matériel.
Veuillez respecter les étapes de montage indiquées et tenir compte des instructions et des
recommandations.
Seul un personnel formé est habilité à effectuer la mise en service des installations.

Table of Contents

Questions and Answers

  • K
    Kimberly MartinAug 11, 2025
    What to do if plugged-in consumer receives no power from weinor Receiver?
    • C
      Charles LaraAug 11, 2025
      If a plugged-in consumer is not receiving power when connected to the weinor Receiver, there are a couple of potential causes. First, the BiRec On/Off may be defective. Try switching it on using the hand transmitter. Alternatively, the consumer itself might be defective, in which case you should replace it.
  • C
    Cindy VaughnAug 20, 2025
    Why is the radio reception poor on my weinor BiConnect BiRec On/Off Receiver?
    • T
      Timothy DownsAug 20, 2025
      Poor radio reception with the weinor Receiver can be caused by devices operating at the same or adjacent radio frequency, or an unfavorable receiver position. Broadband interference in urban areas can also reduce the signal-to-noise ratio. The range is reduced in practical operation due to walls, ceilings etc. Avoid positioning several BiRec On/Offs closely together; a minimum clearance of 0.5 m is recommended to prevent mutual impact.
  • J
    Jeremy Phillips PhDSep 1, 2025
    Why is there no radio reception on weinor BiConnect BiRec On/Off Receiver?
    • J
      Joseph LawsonSep 1, 2025
      No radio reception on your weinor Receiver can be attributed to high-frequency interference, the building structure, vegetation, or conductive metals near the BiRec On/Off. This can influence the antenna's radiation pattern due to the spacing between the dispatcher or receiver and conductive surfaces or objects, including the human body or the ground.

weinor BiConnect BiRec On/Off Specifications

General IconGeneral
TypeReceiver
Frequency868.3 MHz
Channels1
RangeUp to 100 m (open field)
CompatibilityWeinor BiConnect radio system
FunctionalityOn/Off control
Power Supply230 V AC

Related product manuals