Assembly and installation instructions/ Notice de montage et d’installation
We reserve the right to make technical changes/ Sous reserve de modifications techniques
5 Troubleshooting
Plugged in consumer receives
no power
defective
• Consumer is defective
with hand transmitter
• Replace consumer
interference of any kind,
building of any kind and
vegetation, conductive
metals that are in the
proximity of the BiRec
• Influence on the radiation
pattern of the antenna due
to the spacing of the
dispatcher or receiver to
conductive surfaces or
objects (also to the human
at the same or adjacent
radio frequency, lead to
limitation of the operation
or range. Unfavourable
position of the receiver
• The range is reduced in
practical operation due to
walls, ceilings etc.
in urban areas that
reduce the signal-to-
noise-ratio; the signal is
no longer detected in this
noise
• Do not position several
BiRec On/Offs closely
together as they could have
a mutual impact on each
other (recommended
minimum clearance 0.5 m).
To Next Page
Loading...
Need help?
General
