EasyManuals Logo

weinor BiRec MA User Manual

weinor BiRec MA
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
BiConnect BiRec Ma + MA-K
Version 2
2016-04-20
Assembly and installation instructions/ Instructions de montage et d’installation
Item number/
We reserve the right to make technical changes/ Sous reserve de modifications techniques
Numéro d’article
117476-0000
Page 9/28
5 Troubleshooting
Type of fault
Cause
Remedy
Awning does not react to the
signal sent by the hand
transmitter
No power supply
Reconnect power supply
Awning has not been
programmed
Program the awning
Empty batteries in hand
transmitter
Replace batteries
Drive moves in wrong direction
Directions have been
programmed incorrectly
Delete channel and
program correctly
Following a DOWN command,
awning extends only a short
way, then immediately retracts
Receiver is in lock mode:
maximum wind factor on
sun/wind or sun/wind/rain
sensor exceeded
Lock mode is removed
automatically 15-20 minutes
after the maximum wind
factor was last exceeded
BiSens Agido-3V product
protection sensor has
been triggered in last few
minutes
The device unlocks
automatically after 15-20
minutes
Programmed sun/wind or
sun/wind/rain sensor is
faulty or incorrectly
installed
The device will only unlock
when the fault has been
remedied
Awning moves UP and cannot
be halted or extended
"Wind alarm":
Programmed sun/wind
and/or sun/wind/rain
sensor or BiSens
Agido-3V product
protection sensor has
been triggered
The device unlocks
automatically after the
designated period
Following an UP command,
the awning stops after a while
then continues
BiSens Agido-3V battery
empty
Replace batteries in a
programmed BiSens
Agido-3V product protection
sensor
The awning can not be
programmed
a) using a BiEasy
handtransmitter
b) using a Remoto hand
transmitter
a) Program settings for
the unidirectional
transmitter/ sensor
e.g. Remoto still
active
b) Program settings for
the bidirectional
transmitter/ sensor
e.g. BiEasy still
active
Delete old transmitter
completely then program
the awning using the new
transmitter
Table 3: Troubleshooting

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the weinor BiRec MA and is the answer not in the manual?

weinor BiRec MA Specifications

General IconGeneral
Brandweinor
ModelBiRec MA
CategoryReceiver
LanguageEnglish

Related product manuals