16
b) SPM
®
FSR Ribs can NEVER be substituted for SPM
®
FSR
Spines.
c) No SPM
®
FSR Ribs are required, or should be used, on anchor
lines (Anchor lines are the separate SPM
®
FSR lines that secure
the entire SPM
®
FSR system to separate anchor points).
d) SPM
®
FSR Ribs should be installed as tightly as possible.
Excessive play in the overall SPM
®
FSR System could allow
components to release during line failure.
e) In the limited instance where a single SPM
®
FSR Rib is not long
enough to fit around a large component, SPM
®
FSR Ribs can
be “linked” if necessary, but never tied together. For complete
information on linking, see linking instructions on pages 23-25 of
this Installation Guide.
To Next Page
Loading...