4
• SPM
®
FSRs are considered “single-use” items. This means that,
while these components can be installed multiple times out
in the field, if they are actually employed (that is, subjected to
trauma as in the event of a union failing or a pipe rupturing), then
the affected FSR components need to be replaced immediately.
• Always keep ALL personnel away from the flow line while under
pressure. This applies even when a restraint system such as
SPM
®
FSR is in place.
• Installation of individual SPM
®
FSR components as well as
the system itself should be done by Weir Oil & Gas personnel
or persons qualified by Weir Oil & Gas to do so. Training is
available from Weir Oil & Gas, contact 1-800-342-7458 for more
information.
To Next Page
Loading...