What to do if Weishaupt Control Unit shows fault code F9?
If your Weishaupt Control Unit displays fault code F9, it indicates a faulty connection to the Fieldbus. This can happen if there's no query within one minute (Modbus) or the cyclic data flow was interrupted (Profibus). To resolve this, check the Bus connection.
Why does my Weishaupt EM3/2 Control Unit show fault code 18h?
Fault code 18h on your Weishaupt Control Unit indicates several potential issues: * A1h Invalid Bus address: Check the Bus address. * A5h Configuration at output B4 incorrect: Verify the configuration at output B4. * A9h No Bus connection: Check the Bus connection. * EEh Communication to W-FM 25 failed: No solution mentioned. * EFh Extension module to W-FM 25 not compatible: Check the version.
Identifies the intended audience for the manual, including operators and qualified personnel.
Explains the meaning of various safety and informational symbols used throughout the document.
Outlines conditions under which guarantee and liability claims are excluded.
Specifies the intended use of the Fieldbus module EM3/2 with the W-FM 25 combustion manager.
Covers critical safety precautions for electrical connection and proper disposal of the module.
Provides instructions on the physical installation process of the Fieldbus module.
Guides users on configuring the module's DIP switches for network termination and protocol settings.
Details the electrical wiring requirements, including Profibus data rates and Modbus wiring diagrams.
Procedure for setting the Fieldbus address for the module.
Instructions for verifying and configuring the Modbus communication protocol.
Configures how the combustion manager reacts to heat demand.
Instructions for installing the GSD file for Profibus configurations.
Lists common fault codes, their causes, and recommended rectification steps.
Covers Profibus output data, input data, and interface specifications.
Covers Modbus output data and input data specifications.
General| Brand | Weishaupt |
|---|---|
| Model | EM3/2 |
| Category | Control Unit |
| Language | English |
To Next Page
