WEISS DAC501-4ch - Page 23

Weiss Enginering Ltd. DAC501-4ch/DAC502-4ch
• 0dB setting: 3.98 V
rms
+14.3 dBu
• -10dB setting: 1.26 V
rms
+4.3 dBu
• -20dB setting: 0.39 V
rms
-5.7 dBu
• -30dB setting: 0.124 V
rms
-15.7 dBu
→ As input a 0 dBFS sine wave signal was used
→ These levels are achieved with a 0.0 dB setting for the level control on the LCD screen.
Headphone Output:
• (1) stereo 1/4-inch jack connector, DC coupled. The output level is selectable via the LCD menu; four
level settings are provided as shown below:
– 0 dB setting: 8.1 V
rms
+20.4 dBu
– -10 dB setting: 2.55 V
rms
+10.4 dBu
– -20 dB setting: 0.81 V
rms
+0.4 dBu
– -30 dB setting: 0.255 V
rms
-9.6 dBu
→ As input a 0 dBFS sine wave signal was used
→ These levels are achieved with a 0.0 dB setting for the level control on the LCD screen.
Suggested headphone impedances:
• 0 dB setting: 300 Ω or higher
• -10 dB setting: 18 Ω or higher
• -20 dB setting: 5 Ω or higher
• -30 dB setting: 2 Ω or higher
→ The same parameters apply to the 4 pin headphone output of the DAC502-4ch as well.
Synchronization
Via the input signal in case of the AES/EBU and S/PDIF inputs. Via the internal oscillator in the case of USB
and Ethernet inputs.
User Manual and 21 White Papers