8
Section 3
Wiring
Wiring
• All electrical connections and routing must comply with local and national codes.
• Do not modify the factory installed wiring without written factory approval.
• The field wiring must enter through the knockouts provided.
• Refer to the nameplate on the condensing or evaporator coil to determine the proper electrical power supply.
• Wire type should be of copper conductor only and properly sized to handle the electrical load.
• The unit and coil must be properly grounded.
• Condensing unit wiring diagrams are and attached inside the electrical box cover.
• Evaporator coil wiring diagrams are and inside the evaporator cover.
• To view Basic Cooler/Freezer Evaporator Wiring Service Video, scan the QR code below.
• For the latest wiring diagrams, scan the QR code below.
All wiring must comply with local and national codes. Wiring must be performed only by a refrigeration technician or
certified electrician. Failure to follow these guidelines may result in injury!
Check all wiring connections, including factory terminals, before operation. Connections can become loose during shipment
To Next Page
Loading...
