First time selection of USB connectivity
workflow
1. Touch RetinaVue Network - USB to select the USB workflow and touch
Next.
2. Touch OK at the Setup completed screen and follow the touchscreen
instructions to connect the camera to a computer.
Note For the USB workflow, the RetinaVue 700 Imager must
be connected to a computer running the RetinaVue
Network software application (requires additional
software) to transfer exams.
Note To change the connectivity workflow settings after the
initial set up, touch Settings > Advanced settings > Reset
factory defaults. Touch All device settings at the dialog:
"Select the settings to reset to factory defaults." and
then touch OK at the dialog "Reset all settings to
defaults? All exams stored on this camera will be
deleted."
How to set up the camera, then
acquire and submit images – RetinaVue 700
Imager camera and RetinaVue Network
software application (USB only)
18 First time set up of the RetinaVue 700 Imager Welch Allyn RetinaVue™ 700 Imager
To Next Page
Loading...