18
MAINTENANCE
• The major difference between an inverter arc welder and traditional welder is the inverter welder has a lot of advanced
electronic components. Repair of this product can only be carried out by Approved Weldco Technicians.
• As part of general use, the user must carry out all pre-checks and ensure that the welder is maintained. Where the
machine is in contact with dust or contaminants, these must be cleaned off regularly. In dusty environments the power
source will need to be blown down from time to time with dry compressed air at a suitable level. The machine must not
be plugged in when this happens, all care and responsibility must always be maintained to those in the surrounding
area.
• All accessories and leads must be inspected regularly by the user. Any repairs must be done by Approved Weldco
Technicians.
Warning!
Due to high voltage in the main circuit of the welder, DO NOT remove the cover except for
Approved Weldco Technicians. Failure to do so could result in electrocution leading to
injury or death.
WARRANTY
Your Weldco power source is covered by Weldco’s 24-month warranty covering faulty materials and manufacturing.
During this time should your Weldco power source fail please contact your authorized Weldco distributor.
This warranty does not cover freight or goods serviced by un-authorized personnel.
Weldco NZ will inspect your power source for faulty material or workmanship and will only be replaced if repair is not possible.
Note: The warranty is for the power source only. Leads and accessories are consumables and only replaced for failures due to
materials and manufacture.
To Next Page
Loading...