Weldmax Pulse Technik Series - Total Reset; Set-Up (Initial Set-Up of the Welding Power Source)

Cod.006.0001.1440
03/06/2013 v2.2
ENGLISH
300T
10/28
7.2 TOTAL RESET
The reset procedure involves complete restoration of the default values, parameters and memory settings set in the factory.
All memory locations will be reset and hence all your personal welding settings will be lost!
Set the welding power source ON/OFF switch to “O” to switch the unit off.
S3
S5
Hold down both buttons simultaneously.
Set the welding power source ON/OFF switch to “I” to switch on the unit.
SIMULTANEOUS ACTIONS
RECALL PARTIAL SETUP ?
The message appears on the following displays: D2
E1
Select the following setting with the encoder:
RECALL FACTORY SETUP ?
Exit without confirmation
Press any button (except S2).
This action will automatically close the menu.
Exit with confirmation
S3
Press the button.
MEMORY RESETTING NOW........
The message appears on the following displays: D2
This action will automatically close the menu.
Wait for the memory clear procedure to terminate.
8 SET-UP (INITIAL SET-UP OF THE WELDING POWER SOURCE)
Set the welding power source ON/OFF switch to “O” to switch the unit off.
S3
Hold down the button.
Set the welding power source ON/OFF switch to “I” to switch on the unit.
SIMULTANEOUS ACTIONS
SET UP
The message appears for a few seconds on the following displays: D2
SELECT LANGUAGE:
The message appears on the following displays: D2
S3
Use this button to scroll the settings to edit.
E1
Using the encoder, edit the value of the selected setting.
Press any key (except S3) to save the setting and quit the menu.
Tab. 1 - Setup settings
SETTING
MIN
DEFAULT
MAX
SELECT LANGUAGE:
ITALIANO
ENGLISH
FRANÇAIS
DEUTSCH
ESPAÑOL
DUTCH
PORTUGUES
SUOMI
CESKY
POLSKI
COOLER ACTIVATION
OFF
AUT
ON
START CURRENT
%
A
A
*1
FINAL CURRENT
%
A
A
*1
CURRENT HF
20 A
SYN
300 A
KIND OF PULSE
SLOW (*2)
SLOW
FAST (*3)
PILOT ARC
OFF
OFF
ON
*1: The value of this parameter can be set as a percentage of the welding current or as an absolute value expressed in Amperes.
*2: This setting enables slow pulsed mode.
*3: This setting enables fast pulsed mode.