CMP100 User Guide
12
To set input source streaming out, you can make the configuration of the destination in this page.
Multiplex or Bypass stream: You should click the channel line setting icon to make the whole
stream multiplex or bypass out. Click the setting icon ( ), and then you will see the output
module, check the module box, and then you can set the output channel of this stream. After you
select bypass mode, this output channel will be occupied only by this stream and when you set
other stream output channels, this channel will not be available in this time.
Multiplex services: You should click the service line setting icon ( ) to make the certain service
output from certain channel combining with other services. The operation you can refer to
multiplex stream output.
To Next Page
Loading...
