CMP100 User Guide
35
Click plus icon of Descriptor and add the Cable Descriptor in. Then fill in the
correct frequency and symbol rate and choose the correct constellation of the TS
(frequency) and then click OK. (This operation should be set on Modulator
module only)
Do same operations to add next TS (frequency) until NIT streams of all the
frequencies have been included. At last click Apply button to let all configuration
take effect. Then searching programs in your STB, you will get all programs in
order of LCN which you set.
4.3.2 CM-DTMB
CM-DTMB module supports up to 4/8 adjacent frequencies modulating with 1 RF female connector
for output. Operations please refer to CM-QAM-00 pages.
To Next Page
Loading...
