CMP100 User Guide
13
After making output destination configuration, click Apply to make it take effect. The destination
channel will be displayed in the channel/service line. And you can also click Clear Config to clear all
of configuration.
There is a channel scan button ( ) on top, normally the input service list of each
channel will load itself in this page, but when you change the input source, the list could not refresh
immediately, at this time, you should refresh the changed channels manually through the operation
of selecting channel and clicking channel scan button.
3.5 TSoIP output
TSoIP Output >Status
The IP output status information in this page you can check is similar as IP input. The TS analysis
and service list function are also available.
TSoIP Output >Settings
Setting IP output channels is also similar as setting IP input.
To Next Page
Loading...
