42
USER INTERFACE EASY 7
WATER CARE
The Water Care section will help you
set up your ideal filtration and heating
settings. Choose from Away, Standard,
Energy Savings, Super Energy Savings,
and Weekender, depending on your
need. Use Light key to choose your
setting. A checkmark will appear on the
selected icon to confirm.
In Economy mode, the set point will be
reduced by 20°F*, which means that
the heating system will not be engaged
unless the temperature falls to 20°F below
the hot tub's set temperature.
* Default pack value
* Filtration will be reduced when the economy mode is active.
WATER CARE MODES
AWAY:
In this mode the hot
tub will always be
in economy; the set
point will be reduced
by 20° F*.
STANDARD:
The hot tub will
never be in economy
mode and will be
filtering according to
the pack's low level
configuration.
ENERGY SAVINGS
The hot tub will be in
economy mode during
the peak hours of
the day and resume
normal mode on the
weekend*.
SUPER ENERGY
SAVINGS:
The hot tub will always
be in economy mode
during peak hours, ev-
ery day of the week*.
WEEKENDER:
The hot tub will be in
economy mode from
Monday to Friday, and
will run normally on
the weekend*.
MODIFYING SCHEDULES
To see and/or modify a Water Care
category, use the lit button to the right
(Key 1) to open the selected Water Care
menu.
Use the arrow keys to choose a schedule
to modify (choice of economy and
filtration schedules). Use the Light key to
move between parameters.
You have several possibilities for the
schedule (Mon-Fri, weekend, every
day, or single days). The schedules will
be repeated every week. The time and
duration are set in 30 minute increments.
Once you have set the schedule, use Key 1
to go back. Ensure that you have selected
the desired Water Care option in the main
Water Care menu.
The filtration schedule shown on the
screen will apply to the main filtration
pump, most likely pump 1. If your hot
tub uses a circulation pump configured
to run 24 hours, the screen will show you
the purge setting instead of filtration.
The purges are pre-programmed for a
fixed number of minutes, therefore the
duration will be set to N/A on the screen,
and only the start time can be modified.
To Next Page
Loading...
