When using this electrical equipment,
basic safety precautions should always be
followed, including the following:
A) READ AND
FOLLOW ALL
INSTRUCTIONS.
B) A GREEN COLOURED TERMINAL
OR A TERMINAL MARKED G, GR,
GROUND, GROUNDING, OR THE
SYMBOL IS LOCATED INSIDE
THE SUPPLY TERMINAL BOX OR
COMPARTMENT. TO REDUCE THE
RISK OF ELECTRIC SHOCK, THIS
TERMINAL MUST BE CONNECT-
ED TO THE GROUNDING MEANS
PROVIDED IN THE ELECTRIC
SUPPLY SERVICE PANEL WITH
A CONTINUOUS COPPER WIRE
EQUIVALENT IN SIZE TO THE
CIRCUIT CONDUCTORS SUPPLY-
ING THIS EQUIPMENT.
C) AT LEAST TWO LUGS MARKED
“BONDING LUGS” ARE PROVIDED
ON THE EXTERNAL SURFACE OR
ON THE INSIDE OF THE SUPPLY
TERMINAL BOX OR COMPART-
MENT. TO REDUCE THE RISK OF
ELECTRIC SHOCK, CONNECT
THE LOCAL COMMON BONDING
GRID IN THE AREA OF THE HOT
TUB OR SPA TO THESE TERMI-
NALS WITH AN INSULATED OR
BARE COPPER CONDUCTOR NOT
SMALLER THAN NO. 6 AWG.
D) ALL FIELD-INSTALLED METAL
COMPONENTS SUCH AS RAILS,
LADDERS, DRAINS, OR OTHER
SIMILAR HARDWARE WITHIN
3 M OF THE SPA OR HOT TUB
SHALL BE BONDED TO THE
EQUIPMENT GROUNDING BUS
WITH COPPER CONDUCTORS NOT
SMALLER THAN NO. 6 AWG.
E) SAV E T H ESE
INSTRUCTIONS.
IMPORTANT SAFETY INSTRUCTIONS
15
To Next Page
Loading...
