Model WPC-9000Owner’s manual
5
An ambient air adapter can be purchased separately. Air adapter fits over
the condenser to duct condenser air to the unit to improve cooling efficiency.
1.Remove air adapter from carton.
2.Place air adapter on the rear of air conditioner.
3.Use screws (enclosed inside of box with air adapter) to install the adapter
on the air conditioner as shown in Figure 6.
Unlock the casters and push the unit using the side handles to a flat, level surface and set the caster brakes to
the locked position.
Check the prongs and surface of the power cord plug for dust/dirt. If dust and/or dirt are present, wipe off with
a clean, dry cloth.
Check the power cord, plug and prongs for damage or excess play.
If any damage or excess play is found, contact a qualified repair technician or a qualified electrician to perform
replacement or repair of the power cord, plug or prongs.
NOTE: Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign material.
The unit is equipped with an approved NEMA plug configuration (WPC-9000: 6-30P).
The appropriate outlet must be used for each plug type.
Do not use the unit in explosive environments or in areas where flammable
gas leakage may occur.
Assembly (Continued)
If the power cord or plug is damaged, repair should only be performed by
qualified electrical personnel.
Do not connect / disconnect the power cord or attempt to operate buttons with
wet hands. This could result in electrical shock.
Do not install the unit on uneven or sloping surface. The unit may roll or topple
over even if the casters are set to the locked position.
Do not use the unit in areas where it will be exposed to rain or water.
Do not use the unit in a corrosive atmosphere.
Do not use the unit above 18°C(64.4°F) ~ 45°C(113°F).
AMBIENT AIR ADAPTER
(Optional)
Installation
WARNINGS REGARDING PROPER LOCATION FOR INSTALLATION
MOVING THE UNIT
PLUGGING IN THE UNIT
Figure 6
To Next Page
Loading...
Need help?
General
