Model WPC-9000Owner’s manual
7
Maintenance
FILTER CLEANING
(See Figures 8 and 9)
There are two filters in the unit. The evaporator filter is located at the front of the unit. The condenser filter is
located at the side of the unit.
1. loosen up 2 bolts on the front filter guard.
2. Slide filter up and use a vacuum cleaner to remove the dust from the filter.
3. If the filter is heavily covered with dust and dirt, warm water and mild soap or neutral detergent may be used to
wash the filter. Do not use any other chemicals to clean filter, as they will likely damage the filter.
4. Dry the filter in a shaded area before replacing it. Do not operate the unit without the filter installed and the filter
guard in the closed position.
5. Replace the clean filter and close the filter guard.
6. To clean the condenser filter, lift up on the side filter from the middle bar slightly and then angle the filter outwards
from the bottom and remove.
7.Use the same cleaning procedure as above (3 – 5).
8. To replace the condenser filter, place the top of the filter in the guide and slide the filter up until the bottom of the
filter clears the frame.
Then push the bottom of filter into the guide and let filter gently fall inside the guide.
NOTE: For effective cooling clean the filter at least every 2 weeks.
– For your convenience, record the complete model number and product name (located on the Product
Identification Plate), the purchase date, purchase location, serial number, and warranty period in the table below.
– Also, attach your purchase receipt as proof of purchase to this instruction manual for future reference.
– To ensure your product is covered by warranty, the complete faulty product along with your original purchase
receipt must be provided at the place of purchase.
– Loosen up 2 bolts on
the front filter guard.
– Slide filter up and use
a vacuum cleaner to remove
the dust from the filter.
– Remove dust from the filter
using a vacuum cleaner
hose attachment.
– If required wash the filter in
lukewarm water with a mild
detergent. Leave to dry in
a shaded area before
reinstalling.
Figure 8 – Removing Filters
Figure 9 – Removal of Dust
Do not operate the unit with a damaged cord or plug, after the unit malfunctions,
or if the unit has been dropped or damaged.
Do not operate without the filter fitted.
To Next Page
Loading...
Need help?
General
