• Do not fill tank near an open flame.
• Always allow engine to cool for several minutes before refueling.
• Do not overfill (check the "Specifications" section for the tank capacity of this generator).
Always check for fuel spills.
IMPORTANT:
• Use only U_NLEADED gasoline with an octane rating of 87 or higher.
• Do not use old gas.
• Never use an oil/gasoline mixture.
• Avoid getting dirt or water in the fuel tank.
• Never store generator for extended periods of time with fuel in the tank.
Step 3- Ground the Generator
aX WARNING: Failure to properly ground the generator can result in electrocution.
Ground the generator by tightening the grounding nut against a grounding wire (see figure 6). A
generally acceptable grounding wire is a No. 12 AWG (American Wire Gauge) stranded copper wire.
This grounding wire should be connected at the other end to a copper or brass grounding rod that is
driven into the earth.
Grounding codes can vary by location. Please contact a local electrician to check the grounding
regulations for your area.
13
To Next Page
Loading...
