STARTING THE GENERATOR
'W _Before starting the generator, make sure you have read and performed the steps in the
"Preparing the Generator for Use" section of this manual. If you are unsure about how to perform
any of the steps in this manual please call (800) 232-1195 M-F 8-5 CT for customer service.
_k DANGER: POISONOUS GAS. Generators give off carbon monoxide, a poisonous gas that
can kill you quickly. You CANNOT smell it, see it, or taste it.
• ONLY run generator outdoors and away from air intakes, open windows, and garages.
• Never use inside homes, garages, or sheds, EVEN IF you run a fan or open doors and
windows.
If you start to feel sick, dizzy, or weak while using the generator, shut it off and get to fresh air
RIGHT AWAY. See a doctor. You may have carbon monoxide poisoning.
Ak WARNING: This generator produces powerful voltage, which can result in electrocution.
• ALWAYS ground the generator before using it (see the "Ground the Generator" portion
of the "PREPARING THE GENERATOR FOR USE" section).
• Generator should only be plugged into electrical devices, either directly or with an
extension cord. NEVER connect to a building electrical system without a qualified
electrician. Such connections must comply with local electrical laws and codes. Failure to
comply can create a backfeed, which may result in serious injury or death to utility
workers.
• Use a ground fault circuit interrupter (GFCI) in highly conductive areas such as metal
decking or steel work. GFCIs are available in-line with some extension cords.
• Do not use in rainy or wet conditions.
• Do not touch bare wires or receptacles (outlets).
Do not allow children or non-qualified persons to operate.
tL CAUTION: Disconnect all electrical loads from the generator before attempting to start.
Electric Start
To start the generator using the electric start function, perform the following steps:
1. Make sure no electrical devices are connected to the generator. Such devices can make it
difficult for the engine to start.
2. Check that the generator is properly grounded (see page 13, "Ground the Generator").
3. Check the oil and gas levels.
4. Turn the fuel valve to the "on" position (see figure 7).
5. Move the choke rod to the "closed" position (see figure 8).
6. Set the engine switch key to the "on" position.
14
To Next Page
Loading...
Need help?
General
