MAINTENANCE
Blow out or vacuum sawdust or metal chips that accumulate in and on the motor, pulley housing, table,
and work surface.
Apply a light coat of paste wax to the column and table to help keep these surfaces clean and rust-free.
The ball bearings in the spindle and the V-belt pulley assembly are greased and permanently sealed. Pull
the spindle down and oil the spindle sleeve moderately every three months.
Lubricate the table bracket and locking knobs if they become difficult to use.
CAUTION: All servicing of the drill press should be performed by a qualified service technician.
To Next Page
Loading...
Need help?
General
