Wen 4208 Operator's Manual

9
ASSEMBLY AND ADJUSTMENTS
Unpacking (Fig. 2)
Unpack the drill press and all its parts, and compare against the list below. Do not discard the carton or
any packaging until the drill press is completely assembled.
To protect the drill press from moisture, a protective coating has been applied to the machined surfaces.
Remove this coating with a soft cloth moistened with kerosene or WD-40®. Do not use acetone, gasoline,
or lacquer thinner to clean. Apply a coat of good paste wax to the table and column. Wipe all parts with a
clean dry cloth.
A
Head/motor assembly
H
Allen wrench
B
Column assembly
I
Bolts (3)
C
Table
J
Spindle cover knob/bolt
D
Base
K
Feed handles (3)
E
Chuck
F
Chuck key
G
Table lock handle

Wen 4208 Specifications

General

Brand	Wen
Model	4208
Category	Power Tool
Language	English