Wen 56380i Replacement Guide

This is a guide to replacing the multi-meter for your WEN 56380i Inverter Generator. This
guide is best used in conjunction with the 56380i manual, included as a physical copy with
your unit and available on the WEN website page for the 56380i (link here), by clicking “Click
here to view the product manual”.
If at any point you need assistance, have questions, or want to order parts, call WEN customer
service at 1-800-232-1195, M-F, 8-5 Central Time, or email techsupport@wenproducts.com.
If replacing any parts, use only genuine replacement parts purchased from WEN Products. Use of replacement
parts not sold by WEN Products will void your warranty and could lead to decreased performance or injury.
TABLE OF CONTENTS
Tools needed 1
Removing the old multi-meter 1
Installing the new multi-meter 3
TOOLS NEEDED
• Phillips-head screwdriver
• 7mm combination wrench
ENSURE THAT THE ENGINE IS COOL BEFORE BEGINNING ANY MAINTENANCE OR REPAIR WORK. FOLLOW
ALL SAFETY PROCEDURES LISTED IN YOUR OWNER’S MANUAL. USE COMMON SENSE. AVOID INJURY.
REMOVING THE OLD MULTI-METER
1. Disconnect the negative battery wire from the battery according to the instructions in the manual.
2. Disconnect the spark plug boot from the spark plug according to the instructions in the manual.
Fig. 1: Spark plug boot disconnected. Fig. 2: Negative battery wire disconnected.
3. Remove the six screws from around the outside of the panel (red arrows, Fig. 3 below), as well as the screw
from the center of the 3-in-1 knob (blue arrow, Fig. 3 below).
Date last modified: 2020/07/01

Wen 56380i Specifications

General

Running Wattage	3400 Watts
Starting Wattage	3800 Watts
Engine	212cc 4-stroke OHV
Fuel Type	Gasoline
Fuel Tank Capacity	2.2 gallons
Run Time at 50% Load	8.5 hours
Weight	99.2 lbs
Warranty	2 years
Dimensions	23.2 in x 18 in x 20.1 in
Outlets	1 x 120V 30A