OPERATION
Pull the trigger and press down the safety bracket to drive a fastener. Release the safety bracket while hold-
ing down on the trigger, reposition the nailer and engage the safety bracket again to drive the next nail.
NOTE: Double firing may occur if the safety bracket is engaged between shooting nails. So it is recommended
to release the safety bracket quickly after driving each nail.
NOTE: Unit may spark when nails are fired; this is normal.
SHOOTING NAILS
1. Check that the air supply is correctly connected to the tool at the suitable pressure, and the fasteners have
been properly loaded into the magazine.
2. Hold the nailer upright on the workpiece and position the safety bracket where the fastener will be driven.
3a. With Single Sequential Trigger (Black Trigger):
First press down the safety bracket and then pull the trigger. One nail will be driven each time. The nailer
should be allowed to jump off the surface at firing. Disengage the trigger and safety bracket, and reposition
the nailer before shooting the next nail.
3b. With Rapid Fire Trigger (Red Trigger):
WARNING: Before each use, check the nailer, compressed air connections and air lines. If any part
is missing or damaged, do not operate this tool until part is repaired and replaced. Failure to do so
could possibly result in a serious personal injury.
WARNING: User must wear proper eye and hearing protection when operating this tool. Stay alert
and keep proper balance at all times. Keep your fingers away from the trigger when not operating
the nailer to reduce the risk of unintended nail discharge. Failure to do so could possibly result in a
serious personal injury.
WARNING: Never attempt to drive a fastener into materials that are too hard, or at a steep angle,
or near the edge of the workpiece. The fastener can ricochet and cause serious personal injury.
12
WARNING: Do not fire another nail over the position of the existing nail, as the nail may bounce
back and cause serious injury.
4. After operation, turn off the air compressor and depressurize the compressor according to the instructions
included with your compressor. Disconnect the air hose from the nailer. Remove the remaining nails from the
magazine. Follow the instructions in the "MAINTENANCE" section to properly maintain your tool.
To Next Page
Loading...
Need help?
General
