OPERATING THE SPINDLE SANDER
1. Make sure that the machine has been securely
mounted, and all accessories have been properly
installed according to the instructions in the "AS-
SEMBLY & ADJUSTMENTS" section.
2. Plug in and turn ON the sander. Let the spindle
reach full speed.
3. Maintain a firm grip with both hands on the
workpiece for maximum control. Slowly guide the
workpiece against the rotation of the spindle
(Fig. 5).
NOTE: The spindle rotates in a counterclockwise
OPERATION
ON/OFF SWITCH WITH SAFETY KEY
The keyed ON/OFF switch (Fig. 4) is intended to prevent
unauthorized use of the sander.
1. To turn the sander ON, insert the safety key into the key
slot in the center of the switch. Lift the switch up to turn
ON the sander.
3. To turn the sander OFF, push switch down. Remove the
safety key when the sander has come to a complete stop
by gently pulling it out.
direction. Guide the workpiece from the right to left.
If you guide the workpiece in the opposite direction, the
forces of the spinning sanding sleeve will tend to throw or bounce the workpiece away from the sand-
ing sleeve, possibly resulting in injuries.
4. Maintain downward pressure on the workpiece against the table, gently working it along the sanding
sleeve until the desired curve has been created. Do not force the workpiece against the sanding sleeve.
5. When you are finished, turn OFF the sander and wait for the spindle to come to a complete stop.
6. Remove the safety key and unplug the machine from the outlet. Follow the maintenance instructions
on the next page to clean and maintain your sander.
WARNING: Remove the safety key whenever the sander is not in use. Place the key in a safe
place and out of the reach of children.
Fig. 3
Fig. 4
13
ON
OFF
To Next Page
Loading...
Need help?
General
