KNOW YOUR INVERTER GENERATOR
CONTROL PANEL
1 4
1. Indicator Lights
The oil light (yellow) will turn on if the oil is low, the
overload light (red) will turn on if the generator is over-
loaded, and the output light (green) will turn on when
the receptacles have power.
2. CO WATCHDOG Carbon Monoxide Monitor
Measures the accumulation of poisonous CO gas while
the generator is running. If the level of CO gas gets too
high, the CO Watchdog system will automatically shut
down the generator. See p. 28 for more information.
3. AC Circuit Breaker (20A)
4. Parallel Connection Port
Connect two WEN inverter generators through a parallel
connection kit for more output.
5. Data Meter
Displays voltage, frequency, total runtime (HHHH), and
session runtime (HH:MM). Press the MODE button to
switch between displays.
6. AC 120V NEMA TT-30R RV Receptacle (30A)
Standard RV connector.
11
2 3
5
7. Grounding Nut
Ground generator to reduce risk of electric shock.
8. AC 120V NEMA L5-30R Receptacle (30A)
Multipurpose outlet.
9. AC 120V NEMA 5-20R Duplex Receptacles (20A)
Standard household outlets provide 120V 60Hz power.
10. DC 5V USB Ports
The upper and lower USB ports each provide 2.1A.
11. Overload Reset
If the overload light is ON, press this button to reset your
generator.
12. Engine Switch
Start the engine using this switch.
13. Eco-Mode Switch
Flip this switch to ON to increase fuel economy and run-
time when the load is below 2730W (75% load).
710 89111213 6
To Next Page
Loading...
Need help?
General
