PROBLEM CAUSE SOLUTION
Machine does not start.
Machine is not plugged in. Plug machine in.
Wrong extension cord size used.
Use properly-sized extension cord (see
chart on p. 7).
Power outlet does not have power.
Check power outlet for power. Check
breaker for associated circuit. Contact
a professional electrician if necessary.
Safety key not installed. Install safety key.
Breaker tripped. Reset breaker.
Worn carbon brushes. Replace carbon brushes.
Material does not feed
properly.
Dull blades.
Check blades. Rotate or replace as
necessary.
Excessive material has built up in the
dust chute.
Clean out the dust chute. Always use a
dust collection system.
Broken gearbox or drive chain.
Contact customer service at 1-800-
232-1195 for assistance.
TROUBLESHOOTING GUIDE
WARNING! Stop using the tool immediately if any of the following problems occur. Repairs and replace-
ments should only be performed by an authorized technician. For any questions, please contact our customer
service at 1-(800) 232-1195, M-F 8-5 CST or email us at techsupport@wenproducts.com.
18
CLEANING THE PLANER
Keep planer clean of any wood chips, dust, dirt or debris. We strongly recommend always using a dust collection
system. Make sure to clean out the planer after every use.
After 10 hours of operation, the drive chains and sprockets should have wood chips, dust and old grease removed.
While wearing ANSI-Z87.1-approved safety glasses, use a couple puffs of compressed air (do not exceed 50 PSI)
to blow dust and chips out of the gearbox and drive chains.
Use common automotive bearing grease to lubricate all drive chains and sprockets. Spray the gearbox with a light
coat of dry lubricant. Clean the table and infeed / outfeed rollers using a soft, damp cloth. Do not use any waxes,
oils or solvents on the table.
NOTE: The buildup of dust, wood shavings, and other debris can significantly shorten the planer’s useful life. Keep
your planer clean! Failure to do so will void the warranty.
MAINTENANCE
To Next Page
Loading...
Need help?
General
