What to do if my Wen Pressure Washer doesn’t turn on?
First, make sure the pressure washer is properly plugged into a working electrical outlet. If it is, try a different outlet to rule out a defective socket. Check the fuse and replace it if necessary. Finally, if you're using an extension cord, try using the pressure washer without it to see if the cord is defective.
Why does my Wen Pressure Washer stop during operation?
Your Wen Pressure Washer might stop during operation because you blew a fuse. Replace the fuse, and before doing so, turn off other products sharing the circuit. Alternatively, the nozzle could be partially blocked, so try cleaning it.
Why is my Wen Pressure Washer pulsating?
The pulsation in your Wen Pressure Washer could be due to several reasons: * Air may have collected in the inlet hose. To resolve this, allow the machine to run while holding the trigger until adequate pressure returns. * There might be insufficient water supply. Ensure the water tap is open as far as possible. * The nozzle could be blocked. Clean the nozzle. * The water filter might be blocked. Clean the water inlet adapter filter. * The hose could be kinked. Unkink the hose.
What to do if my Wen PW20 Pressure Washer has fluctuating pressure?
Fluctuating pressure in your Wen Pressure Washer can be caused by a few things. The pump might be bringing in air, so tighten the hose connections to ensure they are airtight. Also, the valves could be dirty or broken, requiring cleaning or replacement. Lastly, worn-out pump seals can cause this issue; you can order replacement seals by calling 1-800-232-1195.
What to do if my Wen PW20 Pressure Washer starts without any water?
If your Wen Pressure Washer starts without any water, first, connect the water supply. If that's not the issue, check for a frozen pump or hose and thaw them out. Also, the water filter might be blocked, so clean out the water inlet adapter filter. Finally, the nozzle could be blocked, so unblock and clean it.
Serious injury hazard if spray penetrates skin. Do not point gun at body parts; seek medical aid.
Guide on positioning, connecting water, purging air, and starting the unit safely.
Causes and solutions for the machine stopping unexpectedly during use.
Addresses causes and solutions for a pulsating spray or machine operation.
Troubleshooting steps when the pressure washer fails to power on.
Explains reasons for inconsistent pressure output and how to fix them.
Solutions for intermittent operation where the machine cycles on and off.
Troubleshooting steps for when the machine operates but produces no water.
General| Power | 13 Amp |
|---|---|
| Flow Rate | 1.6 GPM |
| Hose Length | 20 ft |
| Power Source | Electric |
| Motor | Universal |
| Nozzle Types | 0°, 15°, 25°, 40°, Soap |
To Next Page
