To Next PageTo Next PageHow to fix a Wen Pressure Washer when the engine will not start?
If your Wen Pressure Washer engine won't start, there are several possible reasons: * Ensure the engine switch is set to “ON”. * Close the choke. * Add gasoline if the engine is out of fuel. * Change the gasoline if it's contaminated or old. * Clean or replace the spark plug if it's dirty or broken. * Move the generator to a level surface. * Add or replace the oil if it is low.
What to do if the Wen PW2800 Pressure Washer pump fails to produce pressure or has inconsistent pressure?
If the pump of your Wen Pressure Washer fails to produce pressure or the pressure is inconsistent, consider the following: 1. Inspect the garden hose for leaks and ensure it's at least 3/4” in diameter, as a restricted water supply can be the issue. 2. Fully open the water source. 3. Clean the nozzle if it's clogged. 4. Check the spray gun connection or replace the spray gun if it leaks. 5. Squeeze the trigger handle to remove air from the line. 6. Clean the inlet hose screen if it's clogged. 7. Ensure the water supply is not over 100° F and use a cool water supply. 8. If the pump is faulty, contact customer service at 1-800-232-1195 for assistance.
Why is the water pressure weak on my Wen Pressure Washer?
If you're experiencing weak water pressure with your Wen Pressure Washer, it could be due to a few reasons. First, inspect your garden hose for any leaks and ensure you're using a hose with a minimum diameter of 3/4”. A restricted water supply can cause weak pressure. Second, make sure the water source is fully open. Finally, check if you are using the high-pressure nozzle.
General| Brand | Wen |
|---|---|
| Model | PW2800 |
| Category | Pressure Washer |
| Language | English |
