To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if my Wen Pressure Washer doesn’t turn on?
First, make sure the pressure washer is properly plugged into a working electrical outlet. If it is, try a different outlet to rule out a defective socket. Check the fuse and replace it if necessary. Finally, if you're using an extension cord, try using the pressure washer without it to see if the cord is defective.
Why does my Wen Pressure Washer stop during operation?
Your Wen Pressure Washer might stop during operation because you blew a fuse. Replace the fuse, and before doing so, turn off other products sharing the circuit. Alternatively, the nozzle could be partially blocked, so try cleaning it.
Why is my Wen Pressure Washer pulsating?
The pulsation in your Wen Pressure Washer could be due to several reasons: * Air may have collected in the inlet hose. To resolve this, allow the machine to run while holding the trigger until adequate pressure returns. * There might be insufficient water supply. Ensure the water tap is open as far as possible. * The nozzle could be blocked. Clean the nozzle. * The water filter might be blocked. Clean the water inlet adapter filter. * The hose could be kinked. Unkink the hose.
General| Power | 13 Amp |
|---|---|
| Flow Rate | 1.6 GPM |
| Hose Length | 20 ft |
| Power Source | Electric |
| Motor | Universal |
| Nozzle Types | 0°, 15°, 25°, 40°, Soap |
