4
BATTERY CARE
1. Before the first use of the Audio System, fully charge the batteries.
2. Always recharge the batteries after each use, even if the system is operated briefly.
3. Never store the Audio System with partially or fully discharged batteries.
a. Always store the Audio System with the batteries fully charged.
b. During extended periods of storage, connect the power cord to a 120 VAC power source. If this
is not possible, charge the system for 24-hours at least once a month.
BATTERY LED INDICATOR
1. If the Audio System is operating and is not connected to a 120 VAC power source, the Battery LED
will flash when the battery charge is low.
a. An automatic protective circuit will turn the system off when the batteries approach a critical
discharge level (about 15 to 30 minutes after reaching the pre-set discharge level).
CHARGER LED INDICATOR
1. The Charger LED Indicator turns on when the batteries are charging.
2. The Charger LED Indicator flashes when the batteries are fully charged.
CHARGING THE BATTERIES
The Audio System has an internal charging circuit that charges the batteries whenever the system is
connected to a 120 VAC power source. To charge the Batteries, do as follows.
1. Place the Power Switch into the
OFF position.
2. Connect the power cord to a 120 VAC power source.
3. The
CHARGER LED will light.
4. When the batteries are fully charged, the CHARGER LED will flash.
5. Disconnect from the 120 VAC power source.
BATTERY PERFORMANCE
• Battery performance is dependent upon operating volume level, tone control settings, type of
program usage, and if companion loudspeakers are used.
• The Audio System is furnished with a battery set that will provide up to eight hours of continuous
operation when using only the microphone. Battery life is less when using the CD Player (either with
or without the microphone).
BATTERIES
To Next Page
Loading...