1110
QUICK OPERATING GUIDE QUICK OPERATING GUIDE
Read these instructions before using the ladder.
Always keep these instructions with the ladder.
1
Always extend the ladder from the
bottom.
Start to extend the ladder by pulling
upward the two black support rings of
the third rung from the bottom until the
section locks. Repeat this procedure
for each next section until the desired
ladder length is reached.
OPEN
2
Check and ensure that all extended
sections are fully locked and that the
lock indicators are showing full green.
Never attempt to use or climb the ladder
if any of the lock indicators below each
extended section are showing full red or
half red / half green.
3
Note the sloped shape of the ladder
feet and place the extended ladder the
correct way round (forwards) at an angle
of 75 degrees to the ground and
supported at the top. Never climb the
rear of the ladder and never climb the
ladder when placed the wrong way
round (reversed).
4
Place the square pads of the safety
grip wall bumpers at the top of the
ladder against a suitable support (e.g. a
wall). The bumpers provide grip to give
stability. Never support the ladder by the
rungs or stile tubes.
5
Never attempt to climb the ladder if
the sections are in the wrong position
and the distance between all rungs of
the extended ladder are not the same.
Ensure that all sections are opened in
sequence and are fully extended and
locked.
6
To close the ladder support the ladder
in an upright position with one hand and
depress and then release both ladder
lock release buttons with your other
hand. Using both hands, hold outside of
the stile tubes and pull the sections
downward. The lowest extended section
will close rst which will automatically
unlock the next extended section.
Continue to pull down the sections until
the ladder is fully closed.
CLOSED
Also read and follow the
full instructions supplied
with the ladder and the
safety labels affixed to
the ladder.
PN127521-01_IM_TelescopicLadder_A5_Rev A 0922.indd 10-11PN127521-01_IM_TelescopicLadder_A5_Rev A 0922.indd 10-11 03/10/2022 15:3503/10/2022 15:35
To Next Page
Loading...
