Evolution MAX
19
Cleaning combination power head
1. Disconnect the power head from the rod.
2. To release the brush roller from the power head,
press the ‘push’ button and twist the side cap
clockwise. Gently pull the roller from the power
head.
3. If a build-up of debris is wound around the
brush roller, remove by carefully cutting with
scissors. Avoid damaging or cutting the bristles.
4. To replace, carefully slide the brush roller back
into place. Push the side cap down and twist it
anti-clockwise simultaneously until it clicks into
place.
Cleaning hard oor power head
1. Disconnect the power head from the rod.
2. To release the brush roller from the power head,
use a at head screwdriver (not supplied) to
turn the screw and unlock the cover.
3. Lift the small cover to access the brush roller.
4. Lift out the brush roller from the power head.
5. If a build-up of debris is wound around the
brush roller, remove by carefully cutting with
scissors. Avoid damaging or cutting the bristles.
6. To replace, reverse steps 2 - 4. Ensure the brush
roller clicks into position when placed back into
the power head.
To Next Page
Loading...
