9
Clip
Key
Speed Control
Monitor Display
On/Reset Button
BATTERY INSTALLATION
The console
requires two
"AA" batteries
(not includ-
ed). Alkaline
batteries are
recommend-
ed. To install
batteries, open the battery cover as shown at the right.
Press the batteries into the battery compartment, with
the negative (–) ends of the batteries touching the
springs. Close the battery cover, push up on the tab,
and then push the tab forward as shown in the inset
drawing. Be sure that the tab locks into place.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 8.) In addition,
make sure that batteries are installed in the console.
If there is a thin sheet of clear plastic on the console,
remove it.
When you are ready to begin exercising, step onto the
foot rails of the treadmill. Next, find the clip attached to
the key (see the drawing above). Slide the clip onto
your waistband.
Follow the steps below to operate the console.
Insert the key fully into the power switch.
Inserting the key will
not turn on the display.
The display will turn on
when the on/reset but-
ton is pressed or when
the walking belt is
started. Note: If you
just installed batteries,
the display will already be on.
1
CAUTION:Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) while operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
Batteries
Battery Cover
Battery
Cover Tab
DIAGRAM OF THE CONSOLE
To Next Page
Loading...
Need help?
General